Table of Contents
Parts Required #
Collect the following parts for this step:
- Class Echo Back Shell
- Allan Key
- 4 x 5mm M3 Screws
- Arduino Mega 2560 R3
Securing The Arduino #
- Orient the Arduino as shown in the photo, lining it’s screw holes up with the pre-formed holes in the back shell.
- Starting with the middle holes, use the allan key to thread in the M3 x 5 screws.
- DO NOT tighten the screws (the Arduino should still be able to ‘wiggle’) until all screws have been threaded in.
- Once you are satisfied with the Arduino position, lightly tighten the screws (careful – overtightening will strip the holes).
Getting Warmed Up! #
Anyone can be a builder – and you don’t need to be a geek to put together something yourself. Congratulations on completing your first steps, now lets get wiring!
